Tango 19MIMO 2G (GPRS)/3G/4G & GPS Puck Antenna

The Tango 19 is a combination antenna, with two antennas built into a single package.

One is an active GPS antenna with a Low Noise Amplifier (LNA) to boost performance and provide a strong satellite signal strength. The stronger signal allows satellites to be acquired more quickly speeding up application use. The second antenna is a passive 1-2dBi gain Quad Band 2G antenna, allowing for worldwide use with some coverage in 3G and 4G bands.

Supplied as standard with 3 or 5m cable and SMA Male Connectors. Alternative cable lengths or connector types may be specified for volume orders.

Key Features

• MIMO Quad band GSM and GPS active antenna
• Built in LNA with 28dB gain
• Compact puck design
• Best for signal coverage in the following bands:
  • 2G Band 9 (E-GSM-900)
  • 3G Band 8 (E-GSM-900)
  • 3G Band 1 (IMT-2100)
  • 4G Band 20 (800)

Electrical Specifications – GSM Antenna

• Frequency Range: 850/900/1800/1900MHz
• VSWR: <2.0:1
• Gain:
  • 2dBi ±@ 850MHz
  • 2dBi ± @ 900MHz
  • 1dBi ± @ 1800MHz
  • 1dBi ± @ 1900MHz
• Impedance: 50 Ohm

Electrical Specifications – Dielectric Antenna

• Center Frequency: 1575.42MHz
• Impedance: 50 Ohm
• Polarization: RHCP
• Peak gain: > 3dBi (based on 7 x 7cm ground-plane)
• Gain coverage: > -4dBi at -90° < 0 < +90° (over 75% volume)
• Centre frequency: 1575.42 ± 3MHz
• VSWR: <1.5
• Bandwidth: ± 5MHz

Electrical Specifications – GPS Antenna

• LNA gain: (without cable): 28dBi Typical
•  Noise Figure: 1.5dB
• VSWR: <2.0
• Supply Voltage: 2.7 – 5V DC
• Current Consumption: 11 mA Max
• Filter out band attenuation (f0 = 1575.42MHz):
  • 7dB min f0 ± 20MHz
  • 20dB min f0 ± 50MHz
  • 30dB min f0 ± 100MHz

Mechanical Specifications

• Dimensions: L46 Ø x H14.5mm
• GPS Connector: SMA Male
• GSM Connector: SMA Male
• Cable: RG174
• Mounting Method: Screw

Environmental Specifications

• Operating Temperature: -40 to +85°C
• Storage Temperature: -45 – +100°C
• Relative Humidity: 85 ~ 100%RH